Noco GB40 Težave: Če imate težave z zaganjalnikom Noco GB40, obstaja nekaj rešitev, ki jih lahko preizkusite. Prepričajte se, da je baterija pravilno vstavljena. Baterijo postavite na dno enote, srebrni kontakti na bateriji pa morajo biti poravnani s srebrnimi kontakti na enoti.
Pogoste težave z zaganjalnikom NOCO GB40
- Not Charging
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Not Charging: Če se vaš Noco Genius Boost GB40 ne polni, najverjetnejši razlog je baterija ali polnilec. Če ste poskusili različne polnilce in baterije, potem je lahko težava v sami napravi.
Da popravim to, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, mogoče je, da nekaj ovira zvočnik.
Not Working and Solution
Popravek brez polnjenja: Če se vaš Noco GB40 Genius Boost ne polni pravilno, poskusite zamenjati baterijo. Če s tem ne odpravite težave, morda je to posledica okvarjenega polnilnika. V tem primeru, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Nekateri zaganjalniki med polnjenjem oddajajo klikajoče zvoke. To je običajno zato, ker je baterija prehladna ali prevroča. Da bi odpravili to težavo, segrejte baterijo, preden jo poskusite napolniti. Alternativno, poskusite uporabiti drugo vrsto polnilnika za svoj zaganjalnik.
Flashing Red & Zeleno in rešitev
If your NOCO GB40 is flashing red and green, obstaja nekaj stvari, ki jih lahko storite, da poskusite odpraviti težavo. najprej, check the battery level and make sure it is charged. Če je baterija skoraj prazna, charge it for a few hours and then try again. If the battery is charged, try resetting the device by pressing and holding the power button for 10 sekund. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. najprej, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Če to ne deluje, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
najprej, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Naslednji, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Končno, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, you may need to replace it.
Limited capacity and number of ports
najprej, try resetting the device. Storiti to, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Če to ne deluje, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
najprej, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Naslednji, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
najprej, check the battery. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
najprej, check the batteries. If the batteries are low, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, you may need to replace it.
pogosta vprašanja
Q1: Kako uporabljam Noco Genius Boost GB40?
Q2: Kako dolgo zdrži Noco GB40?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Ali Noco GB40 polni baterijo?
ja, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Kako napolnim Genius GB40?
V5: Ali je treba Noco GB40 popolnoma napolniti??
ja, when you get it, fully charge it before first using it to ensure optimal performance.
V6: Ali lahko pustim NOCO boost plus gb40 priklopljen?
ja, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
V7: Kako naj vem, ali Noco genius polni?
Ko se baterija polni, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Ko je baterija popolnoma napolnjena, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Obstaja nekaj različnih načinov za ponastavitev polnilnika Noco GB40. Nekateri ugotovijo, da morajo to storiti, ko polnilnik ne polni njihove naprave ali ko iz polnilnika slišijo klike.
Odstranite baterijo in pomnilniško kartico iz naprave. Izklopite polnilnik na steni. Odstranite baterijo in pomnilniško kartico iz naprave. Držite gumb za vklop za 3 sekund, nato odstranite baterijo in pomnilniško kartico. Ponovno namestite obe bateriji in pomnilniško kartico. Ponovno priključite polnilnik v električno vtičnico. Pritisnite in držite gumb za vklop 3 sekund, nato ga izpustite.
Zelena lučka na polnilniku bi morala ugasniti po približno 10 sekund. Vklopite napravo tako, da pritisnete in približno držite gumb za vklop 5 sekund. Če vse drugo odpove, napravo lahko poskusite ponastaviti tako, da približno približno držite oba gumba hkrati 10 sekund.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Zaključek
Če imate težave z napravo Noco GB40, na primer ne polnjenje ali klikanje, obstaja nekaj stvari, ki jih lahko storite, da jih popravite. If all of above solutions fail, morda je čas, da Noco GB40 odnesete na popravilo.