Masalah Noco GB40: Jika anda mengalami masalah dengan pemula lompat Noco GB40 anda, terdapat beberapa penyelesaian yang boleh anda cuba. Pastikan bateri anda dimasukkan dengan betul. Bateri hendaklah diletakkan di bahagian bawah unit dan sesentuh perak pada bateri hendaklah sebaris dengan sesentuh perak pada unit.
Masalah Permulaan Lompat NOCO GB40 biasa
- Tidak dicas
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Tidak dicas: Jika Noco Genius Boost GB40 anda tidak dicas, sebab yang paling mungkin adalah sama ada bateri atau pengecas. Jika anda telah mencuba pengecas dan bateri yang berbeza, maka masalahnya mungkin dengan peranti itu sendiri.
Untuk membetulkan ini, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, boleh jadi ada sesuatu yang menghalang pembesar suara.
Not Working and Solution
Betulkan tidak mengecas: Jika Noco GB40 Genius Boost anda tidak dicas dengan betul, cuba tukar bateri. Jika itu tidak menyelesaikan masalah, ia mungkin disebabkan pengecas yang rosak. Kalau macam itu, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Sesetengah pemula lompat membuat bunyi klik apabila mereka mengecas. Ini biasanya kerana bateri terlalu sejuk atau terlalu panas. Untuk menyelesaikan masalah ini, panaskan bateri sebelum cuba mengecasnya. Sebagai alternatif, cuba gunakan jenis pengecas yang berbeza untuk pemula lompat anda.
Flashing Red & Hijau dan Penyelesaian
If your NOCO GB40 is flashing red and green, terdapat beberapa perkara yang boleh anda lakukan untuk mencuba dan menyelesaikan isu tersebut. Pertama, check the battery level and make sure it is charged. Jika bateri lemah, charge it for a few hours and then try again. Jika bateri dicas, try resetting the device by pressing and holding the power button for 10 detik. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Pertama, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Jika ini tidak berkesan, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Pertama, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Seterusnya, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Akhirnya, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, anda mungkin perlu menggantikannya.
Limited capacity and number of ports
Pertama, try resetting the device. Untuk membuat ini, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Jika itu tidak berkesan, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Pertama, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Seterusnya, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Pertama, periksa bateri. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Pertama, check the batteries. If the batteries are low, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, anda mungkin perlu menggantikannya.
Soalan Lazim
S1: Bagaimanakah cara saya menggunakan Noco Genius Boost GB40?
S2: Berapa lama Noco GB40 bertahan?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
S3: Adakah Noco GB40 mengecas bateri?
ya, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
S4: Bagaimanakah cara saya mengecas Genius GB40?
S5: Adakah Noco GB40 perlu dicas sepenuhnya?
ya, when you get it, fully charge it before first using it to ensure optimal performance.
S6: Bolehkah saya membiarkan NOCO boost plus gb40 dipalamkan?
ya, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
S7: Bagaimana saya tahu jika Noco genius sedang mengecas?
Apabila bateri sedang dicas, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Apabila bateri telah dicas sepenuhnya, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Terdapat beberapa cara berbeza untuk menetapkan semula pengecas Noco GB40. Sesetengah orang mendapati bahawa mereka perlu melakukan ini apabila pengecas mereka tidak mengecas peranti mereka atau apabila mereka mendapat bunyi klik daripada pengecas.
Keluarkan bateri dan kad memori daripada peranti. Matikan pengecas di dinding. Keluarkan bateri dan kad memori daripada peranti. Tahan butang kuasa untuk 3 detik, kemudian keluarkan bateri dan kad memori. Pasang semula kedua-dua bateri dan kad memori. Sambungkan semula pengecas ke salur keluar kuasa. Tekan dan tahan butang kuasa untuk 3 detik, kemudian lepaskan.
Lampu hijau pada pengecas akan dimatikan selepas kira-kira 10 detik. Hidupkan peranti dengan menekan dan menahan butang kuasa selama kira-kira 5 detik. Jika semuanya gagal, anda boleh cuba menetapkan semula peranti anda dengan menahan kedua-dua butang serentak selama kira-kira 10 detik.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Kesimpulan
Jika anda mengalami masalah dengan peranti Noco GB40 anda, seperti tidak mengecas atau bunyi klik, terdapat beberapa perkara yang boleh anda lakukan untuk membetulkannya. If all of above solutions fail, mungkin sudah tiba masanya untuk mengambil Noco GB40 anda untuk pembaikan.