Noco GB40 Matsaloli: Idan kuna fuskantar matsaloli tare da Noco GB40 jump Starter, akwai 'yan mafita da za ku iya gwadawa. Tabbatar cewa an shigar da baturin ku daidai. Ya kamata a sanya baturin a cikin kasan naúrar kuma a jera lambobin azurfan da ke kan baturin tare da lambobin azurfa a kan naúrar..
Matsalolin NOCO na gama gari GB40 Jump Starter
- Ba Caji ba
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Ba Caji ba: Idan Noco Genius Boost GB40 ɗinku baya caji, Babban dalilin shine ko dai baturi ko caja. Idan kun gwada caja da batura daban-daban, to matsalar na iya kasancewa da na'urar kanta.
Don gyara wannan, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, yana iya yiwuwa akwai wani abu da ya hana mai magana.
Not Working and Solution
Gyara ba caji: Idan Noco GB40 Genius Boost ɗin ku baya caji da kyau, gwada maye gurbin baturin. Idan hakan bai gyara lamarin ba, yana iya zama saboda rashin caja. A haka, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Wasu masu tsalle tsalle suna danna kara lokacin da suke caji. Wannan yawanci saboda baturin yayi sanyi sosai ko zafi sosai. Don gyara wannan matsala, dumama baturin kafin kokarin cajin shi. A madadin, gwada amfani da wani nau'in caja na daban don fara tsallenku.
Flashing Red & Kore da Magani
If your NOCO GB40 is flashing red and green, akwai 'yan abubuwa da za ku iya yi don gwadawa da gyara batun. Na farko, check the battery level and make sure it is charged. Idan baturi yayi ƙasa, charge it for a few hours and then try again. Idan an yi cajin baturi, try resetting the device by pressing and holding the power button for 10 seconds. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Na farko, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Idan wannan bai yi aiki ba, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Na farko, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Na gaba, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Daga karshe, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, kuna iya buƙatar maye gurbinsa.
Limited capacity and number of ports
Na farko, try resetting the device. Don yin wannan, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Idan hakan bai yi aiki ba, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Na farko, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Na gaba, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Na farko, check the battery. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Na farko, duba batura. Idan batura sun yi ƙasa, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, kuna iya buƙatar maye gurbinsa.
FAQ
Q1: Ta yaya zan yi amfani da Noco Genius Boost GB40?
Q2: Yaya tsawon lokacin da Noco GB40 ke ɗauka?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Yana cajin baturi Noco GB40?
Ee, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Ta yaya zan yi cajin Genius GB40?
Q5: Shin Noco GB40 yana buƙatar caji sosai?
Ee, when you get it, fully charge it before first using it to ensure optimal performance.
Q6: Zan iya barin haɓakar NOCO tare da shigar da gb40 a ciki?
Ee, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
Q7: Ta yaya zan iya sanin ko Noco genius yana caji?
Lokacin da baturi ke caji, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Lokacin da baturi ya cika, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Akwai 'yan hanyoyi daban-daban don sake saita cajar Noco GB40. Wasu mutane suna ganin cewa suna buƙatar yin hakan lokacin da cajar su ba ta cajin na'urarsu ko lokacin da suke danna ƙara daga cajar..
Cire baturi da katin ƙwaƙwalwar ajiya daga na'urar. Kashe caja a bango. Cire baturi da katin ƙwaƙwalwar ajiya daga na'urar. Riƙe maɓallin wuta don 3 seconds, sannan cire baturin da katin ƙwaƙwalwar ajiya. Sake shigar da batura da katin ƙwaƙwalwar ajiya. Sake haɗa caja zuwa tashar wutar lantarki. Danna kuma ka riƙe maɓallin wuta don 3 seconds, sai a sake shi.
Hasken kore akan caja yakamata ya kashe bayan kusan 10 seconds. Kunna na'urar ta latsawa da riƙe maɓallin wuta don kusan 5 seconds. Idan komai ya gaza, za ka iya gwada sake saita na'urarka ta hanyar riƙe da maɓallan biyu a lokaci ɗaya na kusan 10 seconds.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Kammalawa
Idan kuna fuskantar matsaloli tare da na'urar ku ta Noco GB40, kamar rashin caji ko danna surutai, akwai 'yan abubuwa da za ku iya yi don gyara su. If all of above solutions fail, yana iya zama lokacin ɗaukar Noco GB40 don gyarawa.