Noco GB40 arazoak: Zure Noco GB40 abiaraztearekin arazoak badituzu, probatu ditzakezun irtenbide batzuk daude. Ziurtatu bateria behar bezala sartuta dagoela. Bateria unitatearen behealdean jarri behar da eta bateriaren zilarrezko kontaktuak unitateko zilarrezko kontaktuekin lerrokatuta egon behar dira..
NOCO GB40 Jump Starter-aren ohiko arazoak
- Ez kargatzen
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Ez kargatzen: Zure Noco Genius Boost GB40 ez bada kargatzen ari, arrazoirik seguruena bateria edo kargagailua da. Kargagailu eta bateria desberdinak probatu badituzu, orduan arazoa gailuarekin bera izan daiteke.
Hau konpontzeko, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, gerta liteke hizlariari oztopatzen dion zerbait egotea.
Not Working and Solution
Konpondu ez kargatzen: Zure Noco GB40 Genius Boost ez bada behar bezala kargatzen, saiatu bateria ordezkatzen. Horrek arazoa konpontzen ez badu, kargagailu akastun baten ondorioz izan daiteke. Kasu horretan, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Jauzi-hasigailu batzuek klik-hotsak egiten dituzte kargatzen ari direnean. Hau izan ohi da bateria hotzegia edo beroegia dagoelako. Arazo hau konpontzeko, berotu bateria kargatzen saiatu aurretik. Bestela, saiatu beste kargagailu mota bat erabiltzen zure abiarazlerako.
Flashing Red & Berdea eta Soluzioa
If your NOCO GB40 is flashing red and green, gauza batzuk egin ditzakezu arazoa konpontzeko. Lehenengoa, check the battery level and make sure it is charged. Bateria baxua bada, charge it for a few hours and then try again. Bateria kargatuta badago, try resetting the device by pressing and holding the power button for 10 segundoak. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Lehenengoa, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Honek funtzionatzen ez badu, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Lehenengoa, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Hurrengoa, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Azkenik, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, you may need to replace it.
Limited capacity and number of ports
Lehenengoa, try resetting the device. Horretarako, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Horrek ez badu funtzionatzen, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Lehenengoa, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Hurrengoa, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Lehenengoa, check the battery. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Lehenengoa, egiaztatu bateriak. Pilak gutxi badira, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, you may need to replace it.
ohiko galderak
Q1: Nola erabiltzen dut Noco Genius Boost GB40?
Q2: Zenbat irauten du Noco GB40-k?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Noco GB40 bateria kargatzen al du?
Bai, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Nola kargatzen dut Genius GB40?
Q5: Noco GB40 guztiz kargatu behar al da?
Bai, when you get it, fully charge it before first using it to ensure optimal performance.
6.G: Utzi al dezaket NOCO boost plus gb40 entxufatuta?
Bai, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
7.G: Nola jakin dezaket Noco genius kargatzen ari den?
Bateria kargatzen ari denean, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Bateria guztiz kargatuta dagoenean, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Noco GB40 kargagailu bat berrezartzeko modu ezberdin batzuk daude. Batzuek uste dute hori egin behar dutela kargagailua gailua kargatzen ez duenean edo kargagailutik klik-hotsak jasotzen ari direnean.
Kendu bateria eta memoria txartela gailutik. Itzali kargagailua horman. Kendu bateria eta memoria txartela gailutik. Eduki sakatuta pizteko botoia 3 segundoak, ondoren, kendu bateria eta memoria txartela. Berriro instalatu bateriak eta memoria txartela. Konektatu berriro kargagailua korronte-hartunera. Eduki sakatuta pizteko botoia 3 segundoak, gero askatu.
Kargagailuko argi berdea itzali behar da gutxi gorabehera 10 segundoak. Piztu gailua pizteko botoia sakatuta eta luze sakatuta 5 segundoak. Beste guztiak huts egiten badu, zure gailua berrezartzen saia zaitezke bi botoiak aldi berean sakatuta gutxi gorabehera 10 segundoak.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Ondorioa
Zure Noco GB40 gailuarekin arazoak badituzu, esate baterako, ez kargatzen edo klik zaratarik, gauza batzuk egin ditzakezu horiek konpontzeko. If all of above solutions fail, baliteke Noco GB40a konpontzera eramateko garaia.