Noco GB40 Problemes: Si teniu problemes amb el vostre arrancador Noco GB40, hi ha algunes solucions que podeu provar. Assegureu-vos que la bateria estigui inserida correctament. La bateria s'ha de col·locar a la part inferior de la unitat i els contactes de plata de la bateria s'han d'alinear amb els contactes de plata de la unitat.
Problemes comuns de l'arrencada de salt NOCO GB40
- No es carrega
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
No es carrega: Si el vostre Noco Genius Boost GB40 no s'està carregant, el motiu més probable és la bateria o el carregador. Si has provat diferents carregadors i bateries, llavors el problema pot ser amb el propi dispositiu.
Per arreglar això, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, podria ser que hi hagi alguna cosa que obstrueixi l'altaveu.
Not Working and Solution
Arreglar no carregar: Si el vostre Noco GB40 Genius Boost no es carrega correctament, prova de substituir la bateria. Si això no soluciona el problema, pot ser degut a un carregador defectuós. En aquest cas, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Alguns iniciadors de salt fan sorolls de clic quan es carreguen. Això sol ser perquè la bateria està massa freda o massa calenta. Per solucionar aquest problema, escalfeu la bateria abans d'intentar carregar-la. Alternativament, proveu d'utilitzar un tipus de carregador diferent per al vostre motor d'arrencada.
Flashing Red & Verd i solució
If your NOCO GB40 is flashing red and green, hi ha algunes coses que podeu fer per intentar solucionar el problema. Primer, check the battery level and make sure it is charged. Si la bateria és baixa, charge it for a few hours and then try again. Si la bateria està carregada, try resetting the device by pressing and holding the power button for 10 segons. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Primer, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Si això no funciona, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Primer, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Pròxim, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Finalment, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, potser haureu de substituir-lo.
Limited capacity and number of ports
Primer, try resetting the device. Fer això, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Si això no funciona, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Primer, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Pròxim, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Primer, comproveu la bateria. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Primer, comproveu les piles. Si les piles estan baixes, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, potser haureu de substituir-lo.
Preguntes freqüents
Q1: Com puc utilitzar Noco Genius Boost GB40?
P2: Quant de temps dura el Noco GB40?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
P3: Noco GB40 carrega la bateria??
Sí, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
P4: Com puc carregar Genius GB40?
P5: Noco GB40 s'ha de carregar completament??
Sí, when you get it, fully charge it before first using it to ensure optimal performance.
P6: Puc deixar NOCO boost plus gb40 connectat??
Sí, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
P7: Com sé si Noco genius està carregant??
Quan la bateria s'està carregant, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Quan la bateria està completament carregada, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Hi ha algunes maneres diferents de restablir un carregador Noco GB40. Algunes persones troben que ho han de fer quan el carregador no està carregant el dispositiu o quan reben sorolls de clic del carregador.
Traieu la bateria i la targeta de memòria del dispositiu. Apagueu el carregador a la paret. Traieu la bateria i la targeta de memòria del dispositiu. Mantingueu premut el botó d'engegada per 3 segons, a continuació, traieu la bateria i la targeta de memòria. Torneu a instal·lar les piles i la targeta de memòria. Torneu a connectar el carregador a la presa de corrent. Manteniu premut el botó d'engegada per 3 segons, després allibera-ho.
La llum verda del carregador s'hauria d'apagar al cap d'aproximadament 10 segons. Engegueu el dispositiu mantenint premut el botó d'engegada durant aproximadament 5 segons. Si tota la resta falla, podeu provar de restablir el dispositiu mantenint premuts els dos botons alhora durant aproximadament 10 segons.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Conclusió
Si teniu problemes amb el vostre dispositiu Noco GB40, com no carregar o fer clics, hi ha algunes coses que podeu fer per solucionar-los. If all of above solutions fail, pot ser que sigui el moment de portar el vostre Noco GB40 per reparar-lo.