Noco GB40 Problemləri: Noco GB40 atlama starterinizlə bağlı problem yaşayırsınızsa, cəhd edə biləcəyiniz bir neçə həll yolu var. Batareyanın düzgün daxil edildiyinə əmin olun. Batareya qurğunun altına yerləşdirilməlidir və batareyanın üzərindəki gümüş kontaktlar cihazın üzərindəki gümüş kontaktlarla düzülməlidir..
Ümumi NOCO GB40 Jump Starter Problemləri
- Doldurulmur
- Not Working
- Clicking Noise
- Flashing Red & Green
- The chords on clamps are very short
- Lack of a wall charger for recharging
- Restricted to 12-volt lead-acid batteries
- Limited capacity and number of ports
- Only has 5V ports
- Jump-starts for less than six times
- Lights keep running
Not Charging and Solution
Doldurulmur: Noco Genius Boost GB40 şarj edilmirsə, ən çox ehtimal olunan səbəb ya batareya və ya şarj cihazıdır. Fərqli şarj cihazları və batareyaları sınamısınızsa, onda problem cihazın özündə ola bilər.
Bunu düzəltmək üçün, remove any loose objects near the device or try pressing down on the speaker until it disappears. If you are hearing clicking noises from your Noco Genius Boost GB40, ola bilər ki, danışığa mane olan bir şey var.
Not Working and Solution
Şarj edilməməsini düzəldin: Noco GB40 Genius Boost düzgün doldurulmursa, batareyanı dəyişdirməyə çalışın. Əgər bu problemi həll etmirsə, qüsurlu şarj cihazı ilə bağlı ola bilər. Bu halda, please reach out to our support team for a replacement charger.
Clicking Noise and Solution
Bəzi tullanan starterlər şarj edərkən klik səsləri çıxarır. Bunun səbəbi adətən batareyanın çox soyuq və ya çox isti olmasıdır. Bu problemi həll etmək üçün, batareyanı doldurmağa çalışmazdan əvvəl onu qızdırın. Alternativ olaraq, atlama starteriniz üçün fərqli növ şarj cihazı istifadə etməyə çalışın.
Flashing Red & Yaşıl və Həll
If your NOCO GB40 is flashing red and green, problemi həll etmək üçün edə biləcəyiniz bir neçə şey var. Birinci, check the battery level and make sure it is charged. Batareya azdırsa, charge it for a few hours and then try again. Batareya doldurulubsa, try resetting the device by pressing and holding the power button for 10 saniyə. If the GB40 still won’t stop flashing red and green, contact NOCO customer support for help.
The chords on clamps are very short
Your NOCO GB40 chords on clamps are very short, there are a few things you can do to fix the issue. Birinci, try to adjust the clamps so that they are not so tight. This will give the chords some slack and allow you to stretch them out a bit. Bu işləmirsə, you can try using a wire cutter to cut the chords. Be sure to cut them as close to the clamps as possible so that you do not damage the clamps.
Lack of a wall charger for recharging
Because of your NOCO GB40 jump starter doesn’t come with a wall charger, you can use a USB cable to recharge it. Just connect the USB cable to the GB40 and then plug it into a USB power source. You can use a USB port on your computer or a USB power adapter.
It’s also important to make sure that the GB40 is properly connected to the power source. The red charging indicator light should be lit up when the GB40 is connected to a power source. If the red light is not lit, check the connections and make sure that the GB40 is properly plugged into the power source.
Once the GB40 is properly connected to a power source, the red charging indicator light will turn off when the GB40 is fully charged.
Restricted to 12-volt lead-acid batteries
Birinci, you’ll want to check the battery terminals to make sure that they are clean and free of corrosion. If the terminals are corroded, you can clean them with a wire brush or by using a solution of baking soda and water.
Sonrakı, you’ll want to check the connections between the charger and the battery. Make sure that the connections are tight and secure.
Nəhayət, you’ll want to check the charger itself to make sure that it is working properly. If the charger is not working properly, əvəz etməli ola bilərsiniz.
Limited capacity and number of ports
Birinci, try resetting the device. Bunu etmək, simply remove the battery and then reinsert it. This should reset the device and hopefully fix the issue.
Əgər bu işləmirsə, then you may need to update the firmware on the device. You can do this by downloading the latest firmware from the NOCO website and then following the instructions on how to update the firmware.
If neither of those solutions work, then you may need to contact NOCO customer support for further assistance.
Only has 5V ports
Birinci, check to make sure that the charging cable is properly connected to the GB40. If the cable is loose or not properly connected, this could be the reason why the GB40 is only outputting 5V.
Sonrakı, try resetting the GB40 by disconnecting it from the power source and then reconnecting it. This sometimes helps to reset the unit and fix any issues that may be causing it to only output 5V.
Jump-starts for less than six times
Birinci, batareyanı yoxlayın. Make sure that it is properly charged and that there are no loose connections.
If the battery seems to be fine, then the next step is to check the jump-start terminals. Make sure that they are clean and free of corrosion.
If the terminals are clean and the battery is charged, then the next step is to check the jumper cables. Make sure that they are the right size and that they are in good condition.
If the jumper cables are in good condition and the right size, then the next step is to check the engine. Make sure that there is no debris blocking the engine from starting.
If the engine is clear and the battery is charged, then the last step is to check the NOCO GB40 itself. Make sure that it is properly connected and that all of the settings are correct.
Lights keep running
Birinci, batareyaları yoxlayın. Batareyalar azdırsa, recharge them or replace them with new ones. If the batteries are not the problem, then the issue may be with the light itself. Try cleaning the light with a soft cloth and see if that helps. If the light is still not working properly, əvəz etməli ola bilərsiniz.
Tez-tez verilən suallar
Q1: Noco Genius Boost GB40-dan necə istifadə edirəm?
Q2: Noco GB40 nə qədər davam edir?
The NOCO GB40’s can last a very long time due to the cycle capabilities of the lithium battery, the key is to charge them once every 6 months if they are in storage.
Q3: Noco GB40 batareyasını doldurur?
Bəli, the Noco GB40 will charge your battery. It is a battery charger and maintainer that is designed to keep your battery charged and in good condition.
Q4: Genius GB40-ı necə doldura bilərəm?
Q5: Noco GB40 tam doldurulmalıdır?
Bəli, when you get it, fully charge it before first using it to ensure optimal performance.
Q6: NOCO boost plus gb40-ı qoşulmuş vəziyyətdə qoya bilərəmmi??
Bəli, the NOCO GB40 has built in overcharge protection and can remain on a charging source at all times.
Q7: Noco dahisinin şarj olub olmadığını necə bilə bilərəm?
Batareya doldurularkən, the charge LED will be illuminated red. The charge LED will remain a solid Red color (not blinking) until the battery is fully charged. Batareya tam doldurulduqda, the charge LED will be illuminated Green.
Q8: How do I reset a Noco GB40 Battery charger?
Noco GB40 şarj cihazını yenidən qurmağın bir neçə fərqli yolu var. Bəzi insanlar şarj cihazı cihazlarını doldurmayanda və ya şarj cihazından klik səsləri aldıqda bunu etməli olduqlarını başa düşürlər..
Batareyanı və yaddaş kartını cihazdan çıxarın. Divardakı şarj cihazını söndürün. Batareyanı və yaddaş kartını cihazdan çıxarın. üçün güc düyməsini basıb saxlayın 3 saniyə, sonra batareyanı və yaddaş kartını çıxarın. Həm batareyaları, həm də yaddaş kartını yenidən quraşdırın. Şarj cihazını elektrik rozetkasına yenidən qoşun. üçün güc düyməsini basıb saxlayın 3 saniyə, sonra buraxın.
Şarj cihazının yaşıl işığı təxminən sonra sönməlidir 10 saniyə. Güc düyməsini təxminən basıb saxlamaqla cihazı yandırın 5 saniyə. Hər şey uğursuz olarsa, hər iki düyməni eyni anda təxminən təxminən basıb saxlayaraq cihazınızı sıfırlamağa cəhd edə bilərsiniz 10 saniyə.
Q9: How many mAh is the NOCO GB40?
The Noco GB40 genius BOOST gets 2150 mAh and 1000 A.
Nəticə
Noco GB40 cihazınızla bağlı problem yaşayırsınızsa, şarj etməmək və ya klik səsləri kimi, onları düzəltmək üçün edə biləcəyiniz bir neçə şey var. If all of above solutions fail, Noco GB40-ınızı təmir üçün götürməyin vaxtı gələ bilər.